What conditions are required for the production of nylon cable ties

All multifunctional cable nylon cable ties are usually long, narrow, and thin. They come in various lengths, total widths and different compressive strengths. These standards must be used in the production process of nylon cable ties:

1. Shaping success is a complicated process

When molten polyester 66 is poured into the mold core, the device must push the nylon material from top to bottom in a short period of time to prevent freezing halfway through.

2. Work pressure must be achieved

When the melting material is transported to the mold core, the process must have a high injection speed and working pressure. Of course, this force is transmitted to the clamping device on the device. If the force is insufficient, you can blow the mold shell.

3. The cable with the die core is long and narrow

The objective fact that the die core is long and narrow indicates that the unique design scheme of the elbow and all clamping structures will be concentrated in the middle of the moving pin. If the elbow and clamping device cannot move the pin as required, problems with the mold are caused by an imbalance of force.

4. Must be injected at high speed

There is a custom forming machine that can take advantage of the lift pump and motor volume to increase injection pressure and injection speed. This helps to quickly fill the die for successful molding. Even so, with each injection and clamping, the impact on the elbow is greater and the same force is transmitted to the clamping module. If these parts are not prepared to digest and absorb the working pressure, they will quickly break down.

5. A lot of manufacturing

Similarly, injection molding must have unique facilities, as this processing technology is mainly used for mass production. Individual cable nylon ties are not worth the whole process on their own. Prepare the plastic in advance and press it into the mold core, and keep the kinetic energy required to clamp the mold shell very high. For these reasons, many components manufactured in series molds are cost-effective.

The most special level of the belt injection molding machine is the molding tool. However, before gradually deteriorating, the melted plastic is usually sent to all parts of the mold shell. This can usually be handled according to automatic doors. Some molding machines use a hot runner system to avoid the plastic freezing or hardening in the die.